Street or Track DOT Stainless Braided Rear Brake Hose Kit

Ends are factory precision crimped to eliminate leakage.  Teflon inner liner and stainless steel braid eliminates hose expansion, common to original lines resulting in better braking performance and a firmer pedal feel! Stainless steel braid is coated in a thick polymeric covering to prevent dirt and other abrasive contaminants entering the braid. This covering provides a significant increase in hose life.

Kit includes:

• 1 x 12" Braided hose with 10mm (3/8) banjo fitting. Hose meets DOT MVSS-106 requirements.
• 1 x 16" Braided hose with 10mm (3/8) banjo fitting. Hose meets DOT MVSS-106 requirements.
• 1 x Adapter for the end of the passenger side hose to OE hard line with 3/8-24 tube nut.  Fitting includes groove for OE style brake line clip (included).
• 1 x Adapter for end of hose to drivers side port on our Intermediate Hose brass block.
• 4 x Crush washers.
• 1 x Brake line clip (passenger side).
• 1 x Clamp on hose bracket (can also be trimmed and welded to passenger axle tube).
• 1 x Hose clamp (used to secure hose bracket if not welded to passenger axle tube).

Fits:

• 1965-70 Mustangs using Cobra/Mach 1/Pony PBR calipers or any other caliper requiring a 10mm (3/8) banjo fitting.

This kit is designed to be used with our Rear Intermediate Brake Hose.  The drivers side hose is configured to fasten directly into the brass block of the intermediate hose kit.  This eliminates extra and unnecessary connections and possible leak points.  Click picture below for larger image: